Don't give in to the temptation to reset the size of your dimensioning text to 1/4". For dimensions, set standard text ht 1/8", and then in the "FIT" tab, set your sizing factor to 2.000. If you want 1/8" text, at plot, use 2x1/8, or 1/4. Lets say you had to "double" the insert size of the title block to get it to look right, around your geometry (you used 2 as your insert scale factor). The trick is, what "Factor" did you use to scale it up? If it was a standard one, the next step will be easier. , you'll have to scale the title-block "UP" to fit it over what you've drawn (1:1, remember?). If you have a fairly big part, or a plot of land, or some other drawing you've drawn that you know is obviously larger than an A-size sheet or B-Size, C-size, D-Size, E-size. You'll use the scale factor step in the insert command for this. Here's how:Īfter you've drawn your geometry (1:1) you can insert your properly sized title block around your geometry. OK- Here might be a good starting place.Īssuming you've drawn your geometry (2D or 3D) at 1:1 scale in model space, the question becomes: How can I scale my text so that when I Plot, text is properly sized? From this question, It may not be hard to see that you have to control this size relationship.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |